酒店布草洗滌是項數量多、質量高的工作，不但要把布草上的汙垢徹底洗掉，而且還要注重延長布草的使用壽命。要想達到理想的效果，必須采用科學的洗滌方法和合理的洗滌程序。
Hotel linen washing is a task with a large quantity and high quality. It is not only necessary to thoroughly remove dirt from the linen, but also to pay attention to extending the service life of the linen. To achieve ideal results, scientific washing methods and reasonable washing procedures must be adopted.
衝水
Flushing water
其目的：一是為了濕潤布草，使織物纖維膨脹，便於汙垢衝離，有利於清除汙垢；二是利用水和機械力的作用盡可能多把被洗布草中水溶性汙垢衝開，以減少程序中洗滌劑的消耗，這一過程無需投任何劑料，隻利用好衝水程序即可達到目的，為此其對後續步驟及降低洗滌成本來說至關重要。
Its purpose: firstly, to moisten the fabric, expand the fabric fibers, facilitate the removal of dirt, and facilitate the removal of dirt; The second is to use the action of water and mechanical force to flush as much water-soluble dirt from the washed linen as possible, in order to reduce the consumption of detergent in the program. This process does not require any additives, and only uses the flushing program to achieve the goal. This is crucial for subsequent steps and reducing washing costs.
目前，有不少洗衣房不設衝水，或認為衝水僅僅是為了濕潤布草，所以布草剛剛浸濕就排水，其實這時的布草還沒有被充分浸泡，達不到衝水去除布草上水溶性汙垢和表麵吸附汙垢的目的，因而不衝水或僅僅浸濕布草的做法不可取的。
At present, many laundry rooms do not have flushing or believe that flushing is only for wetting the linen, so the linen is drained just after it is soaked. In fact, at this time, the linen has not been fully soaked, which cannot achieve the purpose of flushing to remove water-soluble dirt and surface adsorbed dirt on the linen. Therefore, it is not advisable to not flush or only wet the linen.
衝水的水位宜選用中水位。通過實踐證明，高水位水量雖然更充分，但會使洗衣機滾筒轉動產生的機械作用被過多的水減弱不能形成足夠的水的衝擊力，而影響衝水效果。如果選擇中水位，則可以提高水的衝擊力，更好地發揮滾筒的機械作用。所以“衝水”采用中水位為宜，衝水時間2-3分鍾即可。
The water level for flushing should be medium. Through practice, it has been proven that although high water levels provide more sufficient water, they can weaken the mechanical action generated by the rotation of the washing machine drum by too much water and cannot form sufficient water impact, thereby affecting the flushing effect. If you choose a medium water level, you can increase the impact force of the water and better utilize the mechanical function of the drum. Therefore, it is advisable to use a medium water level for flushing, with a flushing time of 2-3 minutes.
水的溫度
Temperature of water
可設在30℃一40℃為宜。水溫過低織物纖維膨脹不明顯，不利於清除汙垢。水溫過高則會使一些汙垢加固在布草上，如含蛋白質的汙垢，在受過高的溫度作用會變質、凝結，要去除就相當困難。衝水次數為1-2次。
It is advisable to set it between 30 ℃ and 40 ℃. If the water temperature is too low, the expansion of fabric fibers is not obvious, which is not conducive to removing dirt. If the water temperature is too high, it will reinforce some dirt on the cloth, such as protein containing dirt, which will deteriorate and coagulate under the action of high temperature, making it quite difficult to remove. The flushing frequency is 1-2 times.
That's all for the explanation of hotel linen flushing and water temperature control standards. We hope you can be helpful. For more information, please come to our website https://www.dngfsy.com Consultation and understanding!
您當前位置: 
